IntraCore™ 3500 Series Gigabit Ethernet Switches Getting Started Guide
10 Getting Started Guide 1.3 Front and Back Panel Descriptions Refer to the following sections for detailed descriptions of the front and back panels
11 Asanté IntraCore 3500 Series From left to right, the back panel, shown below, contains: a console port; a 12V DC jack for an external power supply
12 Getting Started Guide nection to form a stack (multiple units sharing one IP address). The stacking feature is available on the IC3524 models, vers
13 Asanté IntraCore 3500 Series 2 Installation and Setup This chapter explains how to install and connect the switch to your network. To configure th
14 Getting Started Guide •Do not tamper with the internal components of your switch. This could void your warranty •Examine your work area for potenti
15 Asanté IntraCore 3500 Series Failure to observe these limits may cause damage to the switch and void the warranty. Avoid direct sunlight, heat sou
16 Getting Started Guide To mount the switch onto an equipment rack: 1. Place the switch on a flat, stable surface. 2. Locate a rack-mounting bracket
17 Asanté IntraCore 3500 Series 2. Place the unit on a flat surface with a minimum area of 434.3 mm x 342.9 mm (17.1” x 13.5”) and support capacity of
18 Getting Started Guide 2.8.3 GBIC Care and Handling Follow these GBIC maintenance guidelines: •Unnecessary removal and insertion of a GBIC can lea
19 Asanté IntraCore 3500 Series 2.10 Connecting Power Use the following procedure to connect power to the switch: Important! Carefully review the po
2 Getting Started Guide Quick Start Guide Follow these steps to install your IntraCore switch: 1. Open the box and check the contents. See Chapter 1
20 Getting Started Guide Note: There is no uplink port on this switch. All 10/100 ports on this switch are auto-sensing MDI/MDI-X. This advanced featu
21 Asanté IntraCore 3500 Series 2.11.2 Gigabit Ethernet Ports Cabling Procedures Cabling requirements for the Gigabit Ethernet modules depend on the
22 Getting Started Guide • All stacked units are managed through connection to the master switch, via console, telnet or web interfaces Note: W
23 Asanté IntraCore 3500 Series console connection to the first unit. Type k in the Configuration Menu to access the Stacking Management menu, shown b
24 Getting Started Guide 4. After all units have had stacking enabled, connect the console to the first unit (the Master unit). 5. Power cycle the who
25 Asanté IntraCore 3500 Series Appendix A Troubleshooting In the unlikely event your network does not operate properly, follow the troubleshooting t
26 Getting Started Guide
27 Asanté IntraCore 3500 Series Appendix B Safety and Regulatory Com-pliance FCC Compliance Statement This equipment has been tested and found to co
28 Getting Started Guide
29 Asanté IntraCore 3500 Series Appendix C Features and Specifications The IntraCore 3500 Series are Asanté’s most powerful, flexible workgroup switc
3 Asanté IntraCore 3500 Series Table of Contents Quick Start Guide 2 1. Introduction
30 Getting Started Guide
31 Asanté IntraCore 3500 Series Appendix D Serial Port Pin Outs The console port is used to connect with a terminal using a DB-9 female connector. Th
32 Getting Started Guide
33 Asanté IntraCore 3500 Series Appendix E Warranty and Support The IntraCore switch is covered by Asanté’s 3-year IntraCare™ product warranty and ad
34 Getting Started Guide
35 Asanté IntraCore 3500 Series
IntraCore 3500 Series Gigabit Ethernet Switches Getting Started Guide Asanté Technologies, Inc. 821 Fox Lane San Jose, CA 95131 USA SAL
4 Getting Started Guide
5 Asanté IntraCore 3500 Series 1 Introduction Thank you for purchasing the Asanté IntraCore 3500 Series Gigabit switch. The IntraCore 3500 series inc
6 Getting Started Guide The system can operate as a stand-alone network or be used in combination with other IntraCore series switches in the backbone
7 Asanté IntraCore 3500 Series Port # LED Color Description 25,26 Gigabit (speed) Solid Green Off A valid 1000Mbps link has been established No
8 Getting Started Guide 1.2.2 IC3548-2GT The IntraCore 3548-2GT switch has two LED status indicators for each of the 48 10/100 ports and the 2 Gigabi
9 Asanté IntraCore 3500 Series Port # LED Color Description N/A Power/System Green Off Power is on Power is off 1-48 (10/100) Link/Activity Sol
Kommentare zu diesen Handbüchern